Friday, September 18, 2009

WBR-5400 Configuration Guide for Streamyx ISP

*Note: You have to connect your PC to the router and make sure the cable is plug in LAN port and the router is power on.

1. Open your Internet browser, example: Internet Explorer, and key in 192.168.123.254 at address bar.
2. Key in "admin" at the textbox and clik "Login".


3. Click "Wizard".


4. Click "Next" to continue.


5. Select "PPP over Ethernet" mode, then click "Next".


6. Key in username and password for your streamyx, then click "Next".


7. Key in your SSID and select Security to protect your network, then click "Next".


8. Click "Reboot" and click "OK" for save configuration then wait router to reboot and connect to Internet.



*Note: You should be able to enjoy your Internet connection now. If not, kindly make sure your Streamyx username & password are correct, phone cable already plug in to your router and your LAN cable is plug in to your PC horoscope

*For make sure your connection is up, you can go to "Status" and check the Internet status.


*Note: If not, kindly make sure your Streamyx username & password are correct, phone cable already plug in to your router and your LAN cable is plug in to your PC horoscope

* If you need any further assistance on the above kindly call your dealer or email your enquiry to support@ivenue.com.my

1 comment:

  1. Good day. Up till recently, I'd been using my WBR-5400 alongside the modem provided by TMNet to wirelessly stream streamyx signal within my house. Then the modem was fried. And the new replacement modem is also a wireless router, rendering my WBR-5400 useless. Or is it? Because I'm thinking of making a good use of it by wirelessly connecting it to my new modem router (Linksys WAG160N), and place it at the end of the house as streamyx signal booster? If that is possible, would you please help me with the configuration? Cheers ~ Dan.

    ReplyDelete