WSK-3000 WDS configuration Guide

WSK-3000 WDS step by step

TURN OFF your Anti-Virus & Firewall Program, e.g. Norton Anti-Virus before start installation

STEP 1: Launch your internet explorer and key in "192.168.0.1" then press enter
STEP 2: Key in username: admin , password: password. Then press ok.





STEP 3: Click on wireless, region select Asia. SSID: any name you like. Unpick enable WPS. Select enable WDS, and key in router 2 MAC address in AP1, then save it. After save you have to restart the router.





Wireless Router B Setting

Factory Default Setting:
IP Address: 192.168.0.1 Subnet Mask: 255.255.255.0 DHCP: Enable
-------------------------------------------------------------
TURN OFF your Anti-Virus & Firewall Program, e.g. Norton Anti-Virus before start installation

STEP 1: Launch your internet explorer and key in "192.168.0.1" then press enter.
STEP 2: Key in username: admin , password: password. Then press ok.





STEP 3: Click on LAN, and change the IP address to 2 for not IP config with router 1. Then click save.




STEP 4: Click on wireless, region select Asia. SSID: any name you like. Unpick enable WPS. Select enable WDS, and key in router 2 MAC address in AP1, then save it. After save you have to restart the router.




Finally done the step for do WDS please try ping to each router for confirm both are connected.





After completely configure, you can open command prompt for check WDS status.
STEP A: START->RUN..->TYPE ‘cmd’ and press on OK
STEP B: Type "ping 192.168.0.1 -t"
STEP C: Open another command prompt and type "ping 192.168.0.2 -t"
*You should able to see continuous ping response if the WDS done successfully

The ciritcal factors for make the WDS are:
1)IP address for both router must be different and in same range, example Router 1 is 192.168.0.1 and Router 2 is 192.168.0.2
2)Wireless SSID, Security type and password must be same for both router 1 and router 2.
3)All devices should not having same IP address, example modem, printer, PC.
4)Save the setting after configure, and restart the router, and then logout from the router or switch off and switch on the both routers agian.

* If you need any further assistance on the above kindly call your dealer or email your enquiry to support@ivenue.com.my
Posted by Ivenue Tech Team at Friday, October 16, 2009